Flip-up Lens Cover for all Aimpoint 1x Sights (except Micro) - Front
Lens protection that always stays with your sight.
Flips open with one push on the tab.
Tough, flexible polymer composition.
Spring actuated door.

Front Cover
Color: Black
Model: AP12223 (formerly AP10397)

$19.00

Flip-up Lens Cover for Aimpoint Sights (except Micro) - Rear
Lens protection that always stays with your sight.
Flips open with one push on the tab.
Tough, flexible polymer composition.
Spring actuated door.

Rear Cover
Color: Black
Model: AP12224 (formerly (AP10214)

$19.00

Aimpoint Flip up Front Lens Cap Aimpoint Flip up Rear Lens Cap
Back to Optics, Rings, & Hardware

Product Index

Main Page

Made of a tough, flexible polymer, you can install them on any standard 1x Aimpoint sight. Can be used with KillFlash anti-reflection device (ARD). Use them on the CompC series or the 9000 series sights by removing the original rubber ring at the back. These are the same covers currently included with most of the CompM/ML series sights, and will also fit the new CompM4. Install them by pushing straight onto the sight. Do not twist. Once installed, they stay where you put them and you'll never lose them or have to fiddle around to get them on or off. Just push them open and snap them closed. Close only the front cover and you have an "occluded eye gunsight". The rear cover also fits 2x Aimpoint sights. You may find them a bit difficult to install, but some persistence will be rewarded. These covers are designed to fit tight, and to stay where you put them.

A High-End Sight is Your Friend