AK-47 Synthetic Stock Set for Milled Receivers
Buttstock is Intermediate length; 0.75" longer than original (Warsaw Pact) length

Comes with rear sling loop and steel buttplate with trapdoor for cleaning kit.
Requires drilling for rear tang screws.
Mounts on single tang or double tang receivers.
Lower handguard has steel heat shield and steel reinforcements.
Color - Black w/matte finish

Made in U.S.A. (Each part embossed "US")
Discontinued. See AKBMW

Four Piece Synthetic AK Stock for Milled Receiver
Back to AK Products

Product Index

Main Page

View AK Stock Removal and Replacement Instructions

Impervious to the elements, tough, good looking, eminently practical and demands very little of your money-- Totally unlike any Leftist you will ever meet.

The buttstock is 0.75 inches longer than the original Warsaw Pact blueprints. Length of pull approximately 13.37". Some shooters will find it more comfortable, particularly those 6 feet tall or more.

Check federal, state, and local laws for a list of specific infringements pertaining to installation of a pistol grip stock on an AK that did not originally have a pistol grip stock. Some configurations, on some rifles, apparently are so cursed with evil spirits (perhaps these evil spirits are sneaking in from the Old Country on imported firearm parts?) that they may turn you into a law breaker without you even knowing it. Apparently, only your law makers fully understand this curious paranormal phenomenon because no one else has been able to make any sense of it.

Milled AK with Synthetic Stock